Speed Converter
Convert speed between metres per second, kilometres per hour, miles per hour, feet per second and knots.
How it works
converted = value × factor(from) ÷ factor(to)
Sources
- BIPM SI Brochure, 9th edition (2019)
- International yard and pound agreement (1959); one knot = one nautical mile per hour
Worked example: 100 km/h in miles per hour and knots
At 100 km/h the converter shows 62.13711922 mph, because one kilometre per hour is 1/3.6 metres per second and one mile per hour is 0.44704 metres per second. The same speed is 27.77777778 m/s, 91.13444153 ft/s and 53.99568035 knots.
A knot is one nautical mile per hour, and a nautical mile is exactly 1,852 metres, so 1 knot is exactly 1.852 km/h. That is why air and sea speeds do not line up with road speeds at a glance. For weather, wind is usually quoted in km/h on land forecasts and in knots in marine forecasts, so a 30-knot wind is about 56 km/h — a strong breeze rather than a gale.
How the conversion works
All five units are expressed in metres per second, this converter’s base unit. A metre per second is 1, a kilometre per hour is 1/3.6, a mile per hour is exactly 0.44704 (1,609.344 m ÷ 3,600 s), a foot per second is 0.3048, and a knot is 1,852/3,600. The conversion multiplies by the source factor and divides by the target factor.
Two of those factors are exact by definition — the international mile and the nautical mile — while the rest follow from them. Only the displayed digits are rounded, so chaining this converter never accumulates error.
When each unit is used
Kilometres per hour is the road speed unit almost everywhere, including India, Europe and Australia. Miles per hour remains in the United Kingdom and the United States, so any vehicle specification crossing those markets needs converting.
Metres per second is the SI unit and the one used in physics, engineering and wind-tunnel data. Knots are standard in aviation and marine navigation because they pair with nautical miles for distance and with latitude and longitude for position. Feet per second survives in older engineering tables, ballistics and some building codes.
Common mistakes
The classic error is “knots per hour”. A knot already means nautical miles per hour, so a rate of acceleration would be knots per hour, not a speed. Write 20 knots, never 20 knots per hour.
The second is treating a mile as 1.6 km exactly. The factor is 1.609344, so the shortcut drifts by about 0.06% — small per trip, significant over a long distance. The third is confusing nautical and statute miles: 100 nautical miles is 185.2 km, not 160.9 km.
Finally, pace is not speed. A pace of 5 minutes per kilometre is 12 km/h, and inverting a pace without converting its unit produces nonsense figures.
Questions
How accurate is this speed converter?
Conversion factors are exact definitions where such a definition exists, and full precision where it does not. Only the displayed result is rounded.